Gallery of Project Photos: Difference between revisions
No edit summary |
No edit summary |
||
| Line 16: | Line 16: | ||
File:Router Plane.jpg|I used this router plane setup to plow the groves that form the basis of the bead molding. | File:Router Plane.jpg|I used this router plane setup to plow the groves that form the basis of the bead molding. | ||
</gallery> | </gallery> | ||
---- | |||
<div align="center"> | |||
[[Ambry|Return to the Ambry Documentation]] | [[Woodworking|Return to My Woodworking Project Index]] | |||
</div> | |||
[[Category:Woodworking]] | |||
[[Category:SCA]] | |||
Revision as of 17:02, 5 December 2020
- Ambry Project in Process
Close up of the bead profile
Front view of carcass with back attached
Back view of carcass with back attached
view of carcass before the back was attached
A selection of my chisels and rasps for this project. Most work was done with the 12mm single bevel straight chisel.
Back view of the (almost) completed project
Front view of the (almost) completed project
Side view of the (almost) completed project
Top view of the (almost) completed project
The last part, the door.
The blank face frame mortised together and ready for detail work.
Rosehead cut nails as I used in the project and a hand-forged hammer to drive them home.
The hollow plane I used to form the bead molding.
Cleaning up the saw cuts with a rasp. Working vertically with a 2-handed grip helped a lot.
I used this router plane setup to plow the groves that form the basis of the bead molding.
